Evolis Pebble Manual do Utilizador descarregar pdf (Página 20)

EVOLIS CARD PRINTER

Evolis Printers Programming Guide Page 20

Part Number: A5013 Rev. E

P – Parameter Commands

Pem;p1;o1 (Parameter error management)

Tattoo

New Pebble

Dualys

Quantum

Kiosk

ü ü ü ü ü

Sets the error management on the Parallel Port.

p1: 0 Printer manages itself its error.( BUSY stay high on an error).

1 Host Computer + opening cover detection disable

2 Host Computer

3 Host Computer + BUSY Signal not forced in case of error (Centronics) + Status line

managed

4 Does not change the previous Pem value but it sets the ACK/NACK Mode

5 Does not change the previous Pem value but the job is not stopped on a magnetic error.

16 Printer manages itself the error without recovery try (three times for Quantum only)

18 Host computer + without recovery try (three times for Quantum only)

If p1 is equal to some other values, different modes are allowed as described below:

bit1 0 Host Printer / 1 Host Computer

bit2 0 detection of cover opening / 1 cover opening not managed

bit3 0 BUSY Centronic is forced to 1 in case of error / 1 BUSY non forced

bit4 0 Standard Protocol / 1 ACK/NACK Protocol

bit5 0 Standard Error Management / 1 Error Retrieve on ERR_MAGN

Further a switch ON/OFF of the printer, the following parameter becomes null:

- Host Printer, opening cover enable, BUSY forced, Standard Protocol

o1: s The memorized value is downloaded in the saved memory and will be therefore re-loaded

each time the printer power will be switch on.

Pfm;p1 (Parameter Feeder Type)

Tattoo

New Pebble

Dualys

Quantum

Kiosk

ü ü

Set the feeder type.

p1: K Sets the 1000 card capacity feeder

S2 Sets the 500 card capacity feeder with finish sensor detection ON

S3 Sets the 500 card capacity feeder with finish sensor detection OFF

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 68 69

Sem comentários

Evolis Pebble Manual do Utilizador Página 20